This article is for robots running PolyScope X. If your robot runs PolyScope 5, see How to Set the Startup Program for Beacon Cutting (PolyScope 5).
If your Cobot Cutter has the wrong program loaded, load the Beacon Cutting program through System Manager.
Steps
On the teach pendant, open the menu, then tap System Manager.
Tap Programs, then choose cutting_program.
Tap Open.
Enter the safety password (default
ursafe), then tap Apply New Safety.
Tap Confirm Configuration.
Tap Operator.
Open the menu, then tap Reload.
Tap Reload.
How to Verify
After the reload, the teach pendant should show cutting_program is loaded.
Still Need Help?
Tap the Support menu in Beacon to send us a message.