Hirebotics

Change nozzle if spatter does not readily come off

Change the retaining head if the gas ports become clogged

Change the liner if the wire does not feed smoothly

Change the drive rolls if slippage is noticed

1. Change nozzle if spatter does not readily come off
2. Change the retaining head if the gas ports become clogged
3. Change the liner if the wire does not feed smoothly
4. Change the drive rolls if slippage is noticed

The robot controller contains two air filters, one located on each side of the control cabinet.

Gently remove the outer plastic frame, by pulling where the red arrows are shown. The frame will tilt out.

Remove the filter to clean it. Clean using low-pressure air or replace filters if necessary. Remember to clean each side.

1. Gently remove the outer plastic frame, by pulling where the red arrows are shown. The frame will tilt out.
2. Remove the filter to clean it. Clean using low-pressure air or replace filters if necessary. Remember to clean each side.

Periodic Maintenance Tasks for Your Welding Cobot

Maintaining your Welding Cobot

Cobot Welder

Find answers and get help from Intercom Support and Community Experts

Empty Help Center

Uh oh. That page doesn’t exist.

Disappointed

Neutral

Smiley

Title

Track the progress of all tickets related to your company.

Tickets portal.

{assigneeName} needs more information from you

Item	Location	Daily	Weekly	Monthly	Quarterly
Contact Tip	Torch	✅
Air Filters	Robot Cabinet		✅
Nozzle	Torch		✅
Retaining Head	Torch			✅
Liner	Torch			✅
Drive Rolls	Feeder				✅

Periodic Maintenance Schedule

Robot Controller Air Filter Maintenance